how to create a twisted cable

Things You'll Need:
Twisted network cable spool (no RJ45 ends)
RJ45 Modular Jacks
RJ45 Crimping Tool
Scissors

Step 1
Using the crimping tool, insert ¾ inch of the twisted network cable end and remove the cable's coating. You can also use a pocket knife or scissors to strip the wire. Be sure not to cut the wires.
Step 2
Untwist the wires so you have eight individual wires. Sort them in the following order from left to right: Orange White, Orange, Green White, Blue, Blue White, Green, Brown White, Brown.
Step 3
Use the scissors to trim the edges of the wires so all wires are the same length.
Step 4
Insert the wires into a modular jack. Insert with the hook side facing down or away from you. Be sure the wires are inserted completely to the top of the modular jack. Part of the coating should be inserted into the jack as well. If not, remove the wires and trim the wires slightly until part of the coating inserts into the modular jack.
Step 5
Insert the modular jack into the RJ45 slot in the crimping tool. Press the tool together firmly until you hear a small snap. Pull out the modular jack and tug on the cable to be sure the wires are held firmly in place.
Step 6
Measure out the length of cable you need and use scissors to cut the twisted network cable. Repeat the above process on the second end of the cable